Last Updated Friday, July 25 2014
Print

Equipment and Services - Mills and Mixers


Refine by Date:
From: To:
The Milling And Mixing Report
By Bridget Klebaur, Associate Editor
Published January 23, 2014
The market for milling and mixing equipment is expected to grow in 2014, with sales rising in areas such as liquid inks Read More »
The Milling Report
By David Savastano, Ink World Editor
Published January 18, 2013
Milling and mixer manufacturers are working hard to develop new equipment that meets the needs of the ink industry Read More »
The Buyers' Guide
By Staff
Published September 27, 2012
From adhesion promoters to zinc oxide and attritors to waste management services, Ink World’s Annual Buyers’ Guide has everything you may need, as well as important information on suppliers, distributors and trade associations. Read More »
The Milling Report
By Kerry Pianoforte, Ink World Associate Editor
Published January 25, 2012
Milling equipment manufacturers must innovate to stay ahead in these challenging economic times Read More »
By Staff
Published September 22, 2011
Ink World's Annual Buyers' Guide has everything you may need, from adhesion promoters to zinc oxide and attritors to waste management services, as well as important information on suppliers, distributors and trade associations. Read More »
Introducing High Viscosity Immersion Mills HCP S Series
By Barry Cullens, Hockmeyer Equipment
Published January 20, 2011
Editor’s Note: “Introducing High Viscosity Immersion Mills – HCP ‘S’ Series” was presented during the 2010 National Printing Ink Research Institute’s (NPIRI) Technical Conference. Hockmeyer has intr… Read More »
The Milling and Mixing Market
By David Savastano, Ink World Editor
Published January 20, 2011
With the worst of the recession apparently over, ink companies are starting to move forward on their equipment needs Read More »
The Milling and Mixing Market
By David Savastano, Ink World Editor
Published January 12, 2010
For manufacturers of milling and mixing equipment, 2009 was challenging, but there were some signs of improvement near the end of the year. Read More »
By Harry Way, Netzsch Inc.
Published October 16, 2009
Dispersion of carbon black pigment in water via bead milling is very difficult Read More »
The Milling Report
By Kerry Pianoforte, Ink World Associate Editor
Published February 2, 2009
As a result of the economic downturn, milling and mixing manufacturers are further emphasizing the importance of service and new technologies. Read More »
The Milling Report
By Kerry Pianoforte, Ink World Associate Editor
Published February 1, 2008
Milling equipment manufacturers are seeing particular interest in process improvements and new technologies, including nanotechnology. Read More »
The Milling Report
By Kerry Pianoforte, Ink World Associate Editor
Published January 26, 2007
Milling and mixing equipment manufacturers have reported that increasing interest in UV, digital and nanotechnology is creating new opportunities. Read More »
The Milling Report
By David Savastano, Ink World Editor
Published February 6, 2006
With the ink industry showing some growth in 2005, mill manufacturers have seen some improvement in terms of capital expenditures. Read More »
By David Savastano, Ink World Editor
Published October 25, 2005
Process improvement and greater efficiency, reliability and repeatability are among the qualities milling manufacturers are emphasizing. Read More »
By David Savastano, Ink World Editor
Published September 12, 2005
As 2004 opens, mill manufacturers are waiting to see if the economic recovery in the U.S. will lead to greater capital expenditures. Read More »